Charger for Lead-Acid 12/24V 10-300Ah 10A

24 months warranty

The charger is intelligent, controlled by a microprocessor - when fully charged, it automatically switches off, going into voltage monitoring mode - 100% safe for each battery.
The efficiency of our charger is comparable to the charging process in leading professional equipment (even many times more expensive) - theuse of an intelligent charger does not adversely affect the performance of the battery, on the contrary, it prolongs its life!

The charger is not only designed for high-capacity car batteries - thanks to the regulation of the charging current, it is also suitable for gel batteries, motorcycle batteries for yachts, or smaller capacity scooter batteries.

Unlimited possibilities - our charger features a unique, detachable cable with SAE quick connector, allowing you to adapt the charger to your device without problems when the included crocodile clips and loop clamps are not enough.

The charger uses modern solutions:

• Automatic and reliable battery charge management - either when a certain voltage is reached or automatically when the charging current drops,
• Voltage monitoring at the end of charging - automatic resumption of charging when the battery voltage drops, including inthe event of a power failure from the AC grid,
• the charger eliminates battery sulphation that can occur during charging,
• maintenance mode for 12V / SLA batteries with a capacity of 14-230Ah - the charger provides a constant voltage of 13.6V at up to 5A - keeps the battery fully ready - ideal for electric vehicles, forklift trucks etc.
• 13.6V / 5A power mode - can power appliances powered from 12V.
• "Winter mode - guarantees full and efficient charging of the battery even at very low ambient temperatures.
• "revive/refresh " mode - special charging mode - in case of very low batteries, the charger uses a reduced charge 1.The charger itself decides whether to use this mode,
• adetachable cord with SAE quick-connect type allows you to customise the charger to suit your needs, with crocodile clips and loop clamps as standard equipment,
• a charger with protection against short-circuiting, incorrect polarity connection, overheating, overload, etc.

The first stage is the automatic detection of the battery type (12/24V) and its possible reactivation (only for deeply discharged cells) - recharging with reduced current.
The second phase is the main charging - depending on the mode, charging current 10A / 5A / 2A (for 24V batteries the maximum current is 5A).
The next steps are to control the charging process - as the battery voltage increases, the charging current changes (automatic limitation): 10A-7.5A-5A-4A-3A-2A-1.5A.
In the last stage of charging, the current is limited to 1.5 A, which is an excellent protection against the phenomenon of "gassing" of the battery. When the voltage reaches 14.4V (12V batteries) and 28.8V (24V batteries), charging is complete.
The last phase is the battery voltage monitoring phase - leaving the charger connected to the battery for a longer period of time and the voltage drops to 12.8V (12V) / 25.6V (24V), the charger switches on a 1.5 A current charge to prevent the battery from discharging.