Power Supply PoE 24V 1A 24W 2xRJ45 with AC Cable

Extralink poe power adapter (power adapter) designed to supply electricity through selected twisted-pair cable wires to network devices such as media converter, access points, cameras etc. The 24V 1A poe power supply enables the transmission of Gigabit Ethernet network data while supplying power through the same cable. This model allows transmission at the speed of gigagbit eth, is a passive poe solution and does not comply with the ieee 8023ataf standard. Unlike power supplies with 5.5/2.1mm jacks, the Poe adapter allows direct power supply to Gigabit poe devices, no additional network accessories are required.

The power supply has a 1.2 meter long power cable terminated with a clover-type connector, has two RJ45 ports. One of them connects the device to be powered and the other one is used for patchcord connection to a switch or router. It can be installed in places like living quarters, teletechnical rooms or rack cabinets.

The LED indicates the correct operation of the device. If one of the following protections is tripped: short-circuit and overload protection, the power supply cuts off the voltage from the device. After the failure stops, the power supply unit will automatically restore the voltage.

Extralink 24 volt 24 watt PoE power supply.

Extralink PoE power adapter (power adapter) provides power through selected strands of twisted-pair cable to network devices such as media converters, access points, cameras, etc. The 24V 1A PoE power adapter allows Gigabit Ethernet network data transfer while providing power over a single cable. This model is a Passive PoE solution that allows transmission at Gigagbit Ethernet speeds, and is not compatible with the IEEE 8023at/af standard. Unlike power supplies with a 5.5/2.1mm jack connector, the presented PoE adapter directly powers Gigabit PoE devices without the use of additional network accessories.

The power supply is equipped with a 1.2-meter long power cable terminated with a cloverleaf connector and two RJ45 ports, one is used to connect the device to be powered, and the other socket is used to connect a patchcord to a switch or router. The device can be installed in residential, tele-technical rooms or rack cabinets.

The LED indicates the correct operation of the device. In the event of a short-circuit or overload protection tripping, the PoE power supply cuts the voltage to the device, and restores the voltage automatically after the failure is over.